LiveCode Forums.

Livecode 5.5.3
iPhone 4S V6.01
iPad2 V6.01
Both of them are on the same distribution provisioning profile.
I use Airlaunch plugin to make .ipa, html and manifest.plist.
On iPad when I touch the link sent by Airlaunch, my app installs and plays without any problem.
On iPhone it seems to install, but a couple of seconds before the end, a message says it can't install and invites me to try again later...
I have a lot of free memory on the iPhone and it is registered as a device on the portal.
An idea ?
thank you very much !

That message is very common. If the app starts to install, then AirLaunch has already done its job and is finished, but the device has failed Apple's validity check and something has caused iOS to reject the app. Usually that is related to the provisioning profile. If you have added the device to the portal but you have not rebuilt your provisioning profile yet, the installation will fail. You can either use XCode to refresh the profile, or just create a new one in the developer portal.

There is a list of troubleshooting tips about this problem on this page:http://www.hyperactivesw.com/airlaunch/ ... htips.html

Thank you very much !
You are right, it was a refreshing problem.
The earlier you go to sleep, the more refreshing your sleep is.