LiveCode Forums.

I'm trying to first create a line/polygon with code (succeeded) and then if I hold mouse down on the line, to drag/curve the line (unsuccessful).

I've been struggling with this a couple days and didn't want to post here unless i've exhausted all other options.

So, is there perhaps some function in LC to curve between point A to B to C or would I just have to admit defeat and have to write a function to calculate all the 1000(ish) positions for the curve?

Any help will be very much appreciated!

Hi atmosk,

you might want to have a look at Jim Hurley´a Bezier stack at revOnline
http://revonline2.runrev.com/stack/693/Bezier-Line

if that is what you want.

Kind regards

Bernd

Perfect!

Not quite what I had in mind but, with that I will definitely be able to make what I had in mind.

Thanks for your time!

what exactly did you have in mind?
Maybe someone can help.

Kind regards
Bernd

What i had in mind was a magical command/function which would solve my problem (naive at best). What you shared though is exactly what I needed and need to progress with this puzzle.
That's what I tried to say with the above post but my engrish isn't that strong so.. but yea, thanks again