Page 1 of 1
ATEM1 M/E
Posted: Mon Jun 02, 2014 9:06 pm
by Da_Elf
ive been able to code an interface that controls CasparCG and feels proud of myself. Now im trying to see if i can use livecode to send commands to a blackmagic ATEM1 m/e switcher. Has anyone tried this? i dont get any results when doing a search.
Re: ATEM1 M/E
Posted: Mon Jun 02, 2014 9:30 pm
by dunbarx
Not sure what this device will accept as an input in terms of hardware, and what it will understand in terms of drivers or frameworks.
I have used the Bonig und Kallenbach gadgets for projects:
http://www.bkohg.com/serviceusbplus_e.html
They have an RS232 interface that may physically connect to the ATEM device, but you still will have to contend with a driver, which may not exist. You need to contact ATEM and B&K.
Does the ATEM device use DMX 512? Just a thought...
Craig Newman
Re: ATEM1 M/E
Posted: Mon Jun 02, 2014 10:59 pm
by Da_Elf
people have used a software called justmacros to control the ATEM1 but since im using livecode to already control casparCG i wanted to be able to use livecode to control everything
Re: ATEM1 M/E
Posted: Mon Jun 02, 2014 11:24 pm
by Da_Elf
the ATEM is controled on a network via RJ45 with ip addresses