LiveCode Forums.

I want to use the "built-in" visual effects as transitions between cards in a stack. I have no problem with any effects except "zoom" effects. For example, if I use...

visual effect "checkerboard"
go to card "whatever"

... then everything works just fine. But, when I use "zoom close," "zoom open," "zoom in," or "zoom out" nothing happens--it just goes to the specified card. I thought something might be wrong with my stack, so I created a new one to test and got the same issue. I then opened an older stack that I had done that used "zoom" and it no longer worked, either. Then I reloaded my old version 2.5 and tried it. It all worked. Has something changed? Am I doing something wrong? I'm still new at this, so bear with me.

Thanks.

hi Scot,

You're right, the zoom effect is broken :-( The other visual effects still work here (Rev 2.7.2).

Best,

Mark

Thanks. I'm glad it wasn't something I goofed up here. The only effects I used were zoom and push for navigating areas of a timeline, but I can live without zoom until it is fixed (assuming it will be).

Scott
Impressive Image Production

Don't expect it to be fixed soon. This is likely too have no priority at all, although I think this kind of stuff is very basic and shouldn't be broken in the first place. My advice would be to use different effects, until those get broken, too ;-)

Best,

Mark