ATEM1 M/E

[Da_Elf]

ive been able to code an interface that controls CasparCG and feels proud of myself. Now im trying to see if i can use livecode to send commands to a blackmagic ATEM1 m/e switcher. Has anyone tried this? i dont get any results when doing a search.

[dunbarx]

Not sure what this device will accept as an input in terms of hardware, and what it will understand in terms of drivers or frameworks.

I have used the Bonig und Kallenbach gadgets for projects:

http://www.bkohg.com/serviceusbplus_e.html

They have an RS232 interface that may physically connect to the ATEM device, but you still will have to contend with a driver, which may not exist. You need to contact ATEM and B&K.

Does the ATEM device use DMX 512? Just a thought...

Craig Newman

[Da_Elf]

people have used a software called justmacros to control the ATEM1 but since im using livecode to already control casparCG i wanted to be able to use livecode to control everything

[Da_Elf]

the ATEM is controled on a network via RJ45 with ip addresses