Control images don't show in stand alone

WayPastInk · Post by **WayPastInk** » Thu Dec 25, 2008 1:12 pm

Hi all.

Working in Rev Studio 3 on Windows XP.

Things work fine in the development environment however in the stand alone, no control (button) images appear leaving the button working but transparent.

I have tried importing images as control; images as reference control and then ensuring that the original image files were brought along by the stand alone maker.

I am stumped. Never run into this one before. This is also the first stand alone I have tried to make in Rev. 3

Suggestions?

Regards

Mark

hamlynart · Post by **hamlynart** » Fri Dec 26, 2008 12:57 pm

hamlynart · Post by **hamlynart** » Fri Dec 26, 2008 12:59 pm

I'm using a Mac & RR3 so I might not be much use but I thought it might be helpful to mention that I get the same problem on all but control images unless I check "Copy referenced Files" in the "copy" section of the standalone settings.

HTH

Jim H

WayPastInk · Post by **WayPastInk** » Fri Dec 26, 2008 7:53 pm

Thank you.

I tried that and it is not helping.

I noticed that there was sufficient evidence to warrant going to extremes and reformating my working partition and redoing the operating system. Things appear to be working better but I have yet to try making a stand alone. Hope this clears things up.

Regards

Mark