Servo

Quantumfog · Post by **Quantumfog** » Sat Jun 20, 2009 5:02 am

Hello all; despite my familiarity with rev, I have no clue about how to get a signal from a program on my G5 to an external servo to operate robotic devices. Could anyone point me in the right direction?

hamlynart · Post by **hamlynart** » Fri Jul 17, 2009 11:25 pm

What are you using to interface with your servo? If you use an Arduino it is certainly very possible to control the servo with Rev.

Jim

Quantumfog · Post by **Quantumfog** » Sun Jul 26, 2009 8:57 am

I don't have a servo yet; I'm in the process of getting an overview of what is required.

Would the control be through Bluetooth or USB? Could you point to an example or two of Rev code for this?

Thanks for the reply.